Difference between revisions of "Reference Talk:UV Mapping"

From POV-Wiki
Jump to navigation Jump to search
m (follow up)
m (follow up)
Line 28: Line 28:
 
--[[User:Le Forgeron|Le Forgeron]] 16:38, 26 September 2016 (UTC)
 
--[[User:Le Forgeron|Le Forgeron]] 16:38, 26 September 2016 (UTC)
  
* meant as an addition to or a replacement for what was previously added? [[User:Jholsenback|jholsenback]] 11:55, 27 September 2016 (UTC)
+
<p>done [[Reference:UV Mapping#Supported Objects|supported objects]]</p> [[User:Jholsenback|jholsenback]] 23:08, 28 September 2016 (UTC)

Revision as of 23:08, 28 September 2016

  • Additional uv mapping supported objects.

Supported Objects

Surface mapping is currently defined for the following objects:

  • bicubic_patch : UV coordinates are based on the patch's parametric coordinates. They stretch with the control points. The default range is (0..1) and can be changed.
  • box : the image is wrapped around the box, as shown below.
  • lathe, sor : modified spherical mapping... the u coordinate (0..1) wraps around the y axis, while the v coordinate is linked to the object's control points (also ranging 0..1). Surface of Revolution also has special disc mapping on the end caps if the object is not 'open'.
  • mesh, mesh2 : UV coordinates are defined for each vertex and interpolated between.
  • lemon : cylindrical mapping wrapped around the axis from the base point to the cap point.
  • ovus : spherical mapping centered near the center of mass of the ovus (moving from one sphere to another as the ratio of radius progresses).
  • parametric : In this case the map is not taken from a fixed set of coordinates but the map is taken from the area defined by the boundaries of the uv-space, in which the parametric surface has to be calculated.
  • sphere : boring spherical mapping.
  • torus : The map is taken from the area <0,0><1,1> where the u-coordinate is wrapped around the major radius and the the v-coordinate is wrapped around the minor radius.

lemon's detail

the discs on each side get 0.25 each the spindle part gets 0.5 of the range.

[0 to 0.25 base disc, from center to border] [0.25 to 0.75 spindle from base to apex] [0.75 to 1.0 apex disc, from border (0.75) to center]

You might want to rephrase the above for native speaker.

--Le Forgeron 16:38, 26 September 2016 (UTC)

done supported objects

jholsenback 23:08, 28 September 2016 (UTC)